Sun Microsystems WDZF - Setup Procedures; Connecting Your Monitor to a Computer

User’s Manual - 4
Copyright(c) 2007, Sun Microsystems, Inc. All rights reserved.
Setup
Connecting Your Monitor
1. Connect the power cord for your monitor to the power port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet.
2. Using the HD-15 (Analog) connector on the video card.
Co
nnect the signal cable to the 15-pin, HD-15 connector on the back of your monitor.
3. Using the DVI (Digital) connector on the video card.
Connect the DVI Cable to the DVI Port on the back of your Monitor.
5. Turn on your computer and monitor. If your monitor displays an image, installation is
complete.
If you properly connect your monitor using the DVI connector but get a blank screen, push the SOURCE
to see if the monitor status is set to analog.
Rear of monitor
Rear of computer
The monitor features four USB2.0 ports (one upstream and four downstream). Connect the
USB cable to USB port on your system and USB upstream port on your monitor.
4.
DVI cable
VGA cable
USB 2 . 0 cable
button
PPoowweerr ccoorrdd
(not included)(not included)
Analog cable (HD-15)