Sunbeam DF4400 - Care and Cleaning

10
Care and cleaning
Control Probe.
If cleaning is necessary, wipe over with a
damp cloth.
Note: The Control Probe must be removed
before the frypan is cleaned and the Control
Probe inlet must be dried before the
MulticookerDeepFryerisusedagain.
NEVERIMMERSETHECONTROLPROBEIN
WATER OR OTHER LIQUID.
Storage: Store the Control Probe carefully.
Donotknockordropitasthiscandamage
the probe. If damage is suspected, return
the Control Probe to your nearest Sunbeam
Appointed Service Centre for inspection Refer
to the separate warranty and service centre
booklet.
WARNING: Always wait for the fryer vessel
and hot oil to cool down before emptying the
vessel.
Drain off any oil, water or other liquid from
the vessel and remove any food particles.
NEVER PUT COLD WATER INTO
A HOT DEEP-FRYER
Allow the vessel to cool, add tepid water and
let stand, if necessary, to soak and soften
stubborn food particles.
Washing the inside of the vessel
1.Whencooled,removeanyexcess
food particles.
2.Whencooled,washthoroughlyinhotsoapy
water.
Note:Yourcookingvesselisfullyimmersible
in water and is also dishwasher safe.
3. Rinse out in hot or boiling water to remove
unseen fat particles.
Washing the outside of the vessel
Wash grease and oil off the outside of the
vessel with hot soapy water.
Cleaning the basket
1.Removeexcessfoodparticlesfromthe
DeepFryBasket.
2.Placeinhot,soapywaterinasink.Steel
wool or a mild abrasive may be used to
remove stubborn food particles.
3. Rinse and dry thoroughly.
4.Alternately,placethebasketina
dishwasher.
Cleaning the lid
Wash the lid in hot, soapy water. Alternately,
place the lid in a dishwasher.