Sunbeam SB700 - Connecting to Power Source; Power Connection and Operation

Connecting machine to power source
Always make sure that the machine is unplugged from
power source and the main switch is on (O ) “0” when
the machine is not in use and before inserting or
removing parts.
- This machine is equipped with polarized plug which
must be used with an appropriate electrical outlet.
- Connect the machine to a power source as illustrated
(1/2).
-The power switch is located above the terminal box.
Your machine will not operate unless the switch is on
”I”. (1)
-Sewing light turns on automatically when the main
switch is on “I”.
-To start the machine, press the foot control (3). The
speed of the machine is regulated by the amount of
pressure exerted on the foot control.
CAUTION:
Consult a qualied electrician if in doubt as to connect
the machine to power source. Unplug power cord
when machine is not in use.
ATTENTION:
09