Suncast WRP7000 - Assembly Wood Frame

Meijer.com
Assembly/Wood Frame
~·
8411)(188 Ox16
m N ote: At least two
people are needed
during assembly.
1r l.i!J Note : All T-nuts
must be pounded
(with rubber mallet
or hammerJ into
pre-drilled holes
prior to assembly.
IMPORTANT:
When installing any
fastener, DO NOT
overtighten.
• Use an extra washer
if bolts protrude past T-nut .
• If T- nut needs to be removed,
partially thread a screw in to
the nut and hit with a
hammer to disengage T-nut.
• When two wood pieces
attach perpendicular to
each other, make sure
pieces are square.
NOTE: IN THIS
SECTION, ALL HOLES
ARE
PRE-DRILLED.
31
Hardware Needed
•
•
•
•
•
•
0