7
step 2 Fasten the device in the order of M10 nut(A) , hanger(B), wall surface(C) and bolt(D),
where the fastening torque is 37±3N.m.
step 3 Check to ensure COM100 is firmly in place.
-- -- EEnndd
3.3.2 Ground Mounting
For the ground mounting, the device is fixed via the foundation bolts pre-embedded in
the foundation.
step 1 Construct the foundation according to the exterior dimensions of COM100.
step 2 Pre-embed the foundation bolts in the four foundation corners, where the bolts are of
M10.
User Manual 3 Mechanical Installation
To Next Page
Loading...
