10 Operation of LCD Display Panel User Manual
82
Fig. 10-7 Reactive Power Regulation Curve in “IT” Q(U) Mode
10.14.3 Protective Parameters Setting for Italy
If the “Countries” selection is “IT” (Italy), the protective parameters settings
procedures are shown below.
After “Grid codes” selection, you may enter into the
“Pro-param” sub-menu.
Press j to select parameter, Press h to move
cursor right and Press j to set the appropriate
value. Confirm settings by pressing ENTER.
Tab. 10-11 Italy Grid protection Recovery Value
Parameter Explanation
Fmax
recover
Inverter can start operating only when the grid frequency is below
Fmax recovery.
The fault recovery value when the grid over-frequency occurs.
Fmin recover
Inverter can start operating only when the grid frequency is above
Fmin recovery.
The fault recovery value when the grid under-frequency occurs.
Vmax
recover
Inverter can start operating only when the grid voltage is below
Vmax recover.
The fault recovery value when the grid over-voltage occurs.
Vmin recover
Inverter can start operating only when the grid voltage is above Vmin
recover.
The fault recovery value when the grid under-voltage occurs.
To Next Page
Loading...
Need help?
General