SunStar SPS/E-BS1201H - Page 25

25
(5) Selecting Upper Thread Holding Function
For pneumatic type, if you want to use an upper thread holding function, change the parameter as below.
(6) Selecting between Integrated/Separated Pedals
For pneumatic type, if you want to use a separated pedal, change the parameter as below.
A. Turn on the memory switch and press to display
“A-32” on the screen.
B. Press to display the present set-up value.
ⓐ part : 0 : holding device OFF
ⓐ part : 1 : holding device ON
C. Press to change ⓐ “0” to “1”
D. Register the set-up using .
READY
+/FORWARD
READY
+/FORWARD
ⓐ
A-32
󳥴
A-32
󳥴
0
󳥴
1
󳥴
Ex) Using a separated pedal
A. Turn on the memory switch and press to display
“A-33” on the screen.
B. Press to display the present set-up value.
ⓐ part : 0 : integrated pedal
ⓐ part : 1 : separated pedal
C. Press to change ⓐ “0” to “1”.
D. Register the set-up using .
READY
+/FORWARD
READY
+/FORWARD
ⓐ
A-33
󳥴
A-33
󳥴
0
󳥴
1
󳥴
To use a separated pedal as an integrated pedal, press between step B and step C
and change
ⓐⓐ
“1” to “0.” Then register the change using .
READY
-/BACK
Caution