Questions? Call or Text +1 801-658-0015 • 7
Weld Head Setup
Sunstone manufactures a variety of weld heads to accom-
modate a diverse range of welding applications, as shown in
Figure 7.1. Both the parallel and opposed Sunstone weld head
provides a great amount of control and precision. Follow these
abbreviated instructions to connect a weld head to the CDDP.
• Remove the weld head from the box and place it on a
secure work surface.
• Attach the weld head cables to the negative and posi-
tive terminals (see (C) in Figure 6.1).
• For operating the weld head manually, see the weld
head users guide for setup.
• For operating the weld head pneumatically, see the
weld head users guide for setup.
• Turn the welder on, assure the weld head is actuating,
then set the desired energy setting. See Chapter 3 on
how to select desired energy settings.
Note: See weld head user manual for more precise setup infor-
mation.
Hand Held Attachment Setup
Sunstone Engineering manufactures a variety of welding hand
pieces to accommodate a diverse range of welding applica-
tions. Hand piece welding attachments allow ease of use and
versatility. Follow these instructions to connect a hand held
• Remove the hand held attachment from its package.
•
-
ment cables to the negative and positive terminals (see
(C) in Figure 6.1) on the front of the welder, then connect
the 3 pin actuation foot pedal cable to the Ext. Trigger
port (see B in Figure 6.1) on the back of the welder.
• For Pressure Actuated hand attachments (see Figure
7.3), connect the attachment cable to either of the
terminals on the front of the welder and the grounding
Figure 7.3. Pressure Actuated hand held
attachment sample.
Figure 7.2. Dual Probe hand held attachment
example.
Figure 7.1. Weld head connected to the CDDP
welder.
To Next Page
Loading...
