Questions? Call or Text +1 801-658-0015 • 5
Chapter 2: Setup
Pre Setup Information
VOLTAGE AND POWER REQUIREMENTS
detect the voltage, and make the appropriate adjustments automatically.
WELD ACTUATION
The CDDP welder is actuated by means of an external trigger port located on the back of the welder (see page
shows the proper pin placement for custom external trigger cables. The standard external trigger cable con-
nector is an SD-30LP made by CUI Inc.
WELDER BEEPS
-
able or disable the alarm using a switch located on the back of the welder.
THERMAL PROTECTION
-
ing, the operator will hear six successive beeps and will not be able to weld during this time. When the unit has
cooled, the operator will hear three successive beeps, signifying that the unit is again ready to weld.
Figure 5.1. External trigger wiring diagram.
N.O. means “Normally Open.”
N.O. Circuit
N.O. Circuit
Shield
To Next Page
Loading...
