SunTech ST3300 - Enable1; Disable1

ST3300 User Manual
23
● Definition : Stop emergency report.
Field Definitions Unit Remark
CMD_ID “AckEmerg” Acknowledgement of emergency report.
The device will stop emergency reports if it is in emergency
state.
<example>
[command] ST3300CMD;850000;02;AckEmerg
[response] ST3300CMD;Res;850000;010;AckEmerg
4-11-5. Enable1
● Definition : Active Output1.
Field Definitions Unit Remark
CMD_ID “Enable1” Enable Output1
<example>
[command] ST3300CMD;850000;02;Enable1
[response] ST3300CMD;Res;850000;010;Enable1
[response] ST3300CMD;Res;850000;010;Enable1NoUse (in case that IN type is set to ‘No Use’).
<notes>
** Output1 line goes to active status.
** If OUT1 set with immobilizer, output1 line goes to active status gradually with pulse in driving mode.
** If OUT1 set with pulse type, output1 line generates pulse and returns inactive state after pulsing out
automatically.
4-11-6. Disable1
● Definition : Inactive Output1.
Field Definitions Unit Remark
CMD_ID “Disable1” Disable Output1