SWDM320HB OPERATOR’S MANUAL
10）Apply paint on necessary places of the machine to avoid rust, such as, apply
grease to protect telescopic beam surface and mast track.
11）Keep the machine in a safe dry place. If it’s stored outdoor, water-proof cover
should be placed.
12）During storage, regularly clean gear ring and drive sprocket surface and check for
rust, grease it if necessary.
7.14.2.2 Maintenance after Storage
Note：
Start the machine in a ventilation space.
If the machine is stored for a long time, the oil layer on the sliding surface may be
damaged. It’s necessary to travel, swing, or operate the hydraulic system for two to
three times to lubricate the sliding surface.
1）Lubricating grease should be removed if the hydraulic cylinder piston rod is applied
before storage.
2）Adjust belt tension for A.C.generator and fan.
3）Check all hoses and the connection.
4）Install new fuel filter, change engine oil filter and inject oil into engine.
5）Fill up the fuel tank and exhaust air for the fuel system.
6）Check all liquid level and oil quality.
7）Start engine and run it at half speed for a few minutes before full loaded.
8）Operate all hydraulic function circularly for several times.
Note: Following procedures should be done after the machine is kept for a long
time.
1）Check all hoses and the connection.
2）Preheat the engine.
3）Switch off the engine.
4）Install a new fuel filter. Change engine oil filter and inject oil into the engine.
7.14.3 Daily Maintenance
Check oil tank capacity and oil quality.
Check oil leakage.
Check wire ropes of main winch and auxiliary winch for damage, reliable connection
and enough strength of rope retainer.
To Next Page
Loading...