5.3 SERVICING SCHEDULE CONTENT
A – EVERY DAY OR EVERY 10 HOURS SERVICE
A1-- Engine oil level.
A2-- Check the cooling fluid level.
A3-- Check the fuel prefilter.
A4-- Cheak the level of the hydraulic driver oil
B -- EVERY 50 HOURS SERVICE
B1-- Clean the air filter.
B2-- Check the hydraulic oil level.
B3-- Check the tyre pressure and wheel nut torque.
B4-- Clean the radiator.
B5-- Clean and grease the telescopic boom pads.
C -- EVERY 250 HOURS SERVICE
C1-- Alternator-fan-camshaft belt tension.
C2-- Check the oil level in the axle differential front and rear.
C3-- Check the oil level in the front and rear wheel final drivers
C4-- Check the oil in the 2 speed reduction gear on the front axle.
C5-- Grease the pivot pin of telescopic boom.
C6-- Grease the pivot pin of quick coupling.
C7-- Grease the pins of fork tilting cylinder foot and rod.
C8-- Grease the pins of lifting cylinder foot and rod.
C9-- Grease the pins of front and rear axle.
C10-- Grease the pins of front and rear axle soleplate
C11-- Grease the pins of the cardan jiont.
C12-- Grease the pins of the leveling cylinder.
C13-- Check,clean and lubricate the outside chains of the boom.
C14-cheak the chains tension
C15-- Replace the engine oil filter.and drain and replace the engine oil.
D -- EVERY 500 HOURS SERVICE OR EACH YEAR
D1 -- Replace the air filter cartridge.
D2 -- Replace the primary fuel filter/water separator
D3 -- Replace the secondary fuel filter.
D4 -- Replace the hydraulic oil filter cartridge.
D5 -- Replace the hydraulic and transmission oil vent.
D6 -- Replacethe hydraulic driver oil and the element.
E -- EVERY 1000 HOURS SERVICE OR EACH YEAR
E1 -- Change the hydraulic and transmission oil
E2 -- Change the oil in the front and rear axle differential.
E3 -- Change the oil in the front and rear wheel final driver
E4 -- Change the oil in the front axle reduction gear.
E5 -- Change the fuel and clean the fuel tank.
E6 -- Change the engine belt
E7 -- Control the telescopic sliding block wear *
F-- EVERY 2000 HOURS SERVICE
F1 -- Check the valve clearance.
F2 -- Check the oil injectors.
F3 -- Check the alternator and starter motor.
F4 -- Check the turbocompressor.
G -- EVERY 5000 HOURS SERVICE
G1 -- Check interior chain wear
G2 -- Check for stretching due to wear
To Next Page
Loading...
