5.4.8 OCCASIONAL MAINTENANCE
H1:Engine maintenance
Plesea read the operation manual of Deutz
H2: Change a wheel
In the event of a wheel being changed on the public highway, make sure of the following points :
Stop the lift truck, if possible on even and hard ground.
To pass on stop of lift truck (See chapter :DRIVING INSTRUCTIONS in paragraph :
1 - OPERATING AND SAFETY INSTRUCTIONS
Action the parking brake
Put the warning lights on.
Immobilise the lift truck in both directions on the axle opposite to the wheel to be changed.
Unlock the nuts of the wheel to be changed.
Place the jack under the flared axle tube, as near as possible to the wheel and adjust
the jack.
Lift the wheel until it comes off the ground and put in place the safety support under the axle.
For this operation, we advise you to use the hydraulic jack and the safety support.
Completely unscrew the wheel nuts and remove them.
Free the wheel by reciprocating movements and roll it to the side.
Slip the new wheel on the wheel hub.
Refit the nuts by hand, if necessary grease them.
Remove the safety support and lower the lift truck with the jack.
Tighten the wheel nuts with a torque wrench
To Next Page
Loading...
