B3: Check the tyre pressure and wheel nut torque.
Check and adjust the tyre pressure
Check the condition of the tyres. There should be no cuts, signs of wear, etc.
Check that the wheel nuts are correctly torqued
Attention：Failure to comply with these instructions could lead to damage and breakage of the
wheel studs and distortion of the wheels themselves.
Wheel nut torque：550Nm
B4: Clean the radiator.
To prevent the radiator from clogging, it must be cleaned with a jet
of compressed air from the inside towards the outside ,This is the
only way to clean off the debris.
B5: Clean and grease the telescopic boom pads
Completely extend the telescopic boom.
Clean the surface of the telescopes
Using a brush, apply a layer of grease (see “LUBRICANT” chart) on all 4 sides of the telescopic
boom .
Operate the telescopic boom several times to evenly distribute the grease.
Remove any excess grease.
To Next Page
Loading...
