Operation
52 NT 10000...NT 12000
306:T. meas. The NT Solar Inverter is equipped with a
temperature sensor that monitors the
heat sink temperature. This message ap-
pears if the sensor reports a value outside
its value range or if the sensor cable is da-
maged.
The ambient temperature of the Solar In-
verter is outside the permissible range (<
-25°C).
Wait until the temperature is back in
the permissible range.
A cable break has occurred in the sensor
which monitors the heat sink tempera-
ture.
Please contact the Technical Hotline.
The phone number is provided on the
back of the manual.
307:Overtmp.
(Warning)
Your Solar Inverter is designed for an am-
bient temperature of up to +45?. When a
specified temperature threshold of the
heat sink is reached, the feed line is line-
arly reduced in size. Should the heat sink
temperature nevertheless continue to in-
crease, feeding is stopped. This warning
appears when the current heat sink tem-
perature is just below the switch-off
threshold.
The maximum permissible ambient tem-
perature has been exceeded.
The installation location is not suitab-
le. Please find another installation lo-
cation.
The air circulation requirement was not
taken into account during installation.
Clean the Solar Inverter, if dirt pre-
vents cooling.
Observe the installation distances
specified in the manual.
Objects were laid on the heat sink and
unimpaired convection was prevented.
Remove the objects.
309:control The software version of the control soft-
ware is incompatible.
Carry out a software update.
310:no config No country is set. Contact the Technical Hotline for the ins-
taller password. The phone number is
provided on the back of the manual. Re-
set the country of installation according
to the explanatory notes in section 4.2
Commissioning.
Interface/communication fault
401:SD card The Solar Inverter cannot find an SD card. Restart the Solar Inverter.
If the error still occurs, please contact the
Technical Hotline. The phone number is
provided on the back of the manual.
402:SD card The SD card is write-protected. Restart the Solar Inverter.
If the error still occurs, please contact the
Technical Hotline. The phone number is
provided on the back of the manual.
403:CAN user Communication error with CAN user. Check whether an error has occurred
in the secondary CAN unit. Restart
the secondary unit and main unit if
necessary.
Display message Description Cause and possible remedies
To Next Page
Loading...
