NT 10000...NT 12000 77
A Appendix
A.1 Drilling template for the wall bracket
You can use the following template for installing the wall bracket. The template
shows all distances and dimensions.
A.2 General liability disclaimer
Although information contained in this manual has been checked with the gre-
atest care for its accuracy and completeness, not liability whatsoever can be ac-
cepted for errors or omissions.
Sunways AG reserves the right to change the hardware and software fea-
tures described here at any time without prior notice.
This manual may not be reproduced, passed on, copied or translated into
other languages in whole or in part in any form or with any means without
prior written approval by Sunways AG.
Sunways AG shall assume no guarantee for damage caused by faulty or lost
data, due to incorrect operation or the malfunction of the Solar Inverter, the
software, additional devices or PCs.
All rights reserved. © Sunways
AG
The products named on cover page are protected by copyright and sold under
licence. No part of this document may be reproduced in any form without prior
written approval of Sunways AG and the Sunways licensors.
Registered trademark The Sunways logo is a registered trademark of Sunways AG, Konstanz.
HERIC
®
is a registered trademark of Fraunhofer Gesellschaft, Munich.
470
10
10
12
10,50
R
5
,
2
5
100
To Next Page
Loading...
