Sunways STT-4KTL - Country Code (Safety Code) Setting; Auto-Test

40 41
6.1.2 LAN/WIFI Setting
LAN Reset
Setting
DHCP Set
Setting
IP Address
Setting
Gateway
Address
Setting
Subnet Mask
Setting
DNS Address
Setting
WIFI
Reset
WIFI
Reload
SettingSetting
DHCP ON
OR
OR
Note
Please wait for 10seconds and the inverter will automatically save your settings or modi-
󽗉cations.
※ 6.2 Country Code (Safety Code) Setting
Please set "Country code (Safety code)" under the menu "Safety Set" in " General Settings ".
Please follow this 󽗊ow chart to set "Country code (Safety code)":
6 General Operation
Main
Window
Safety Set
Setting
General
Settings
Short press(1s),switch window
Long press(3s),enter the lower Menu
6 General Operation
※ 6.3 Auto-Test
This function is disabled by default, and only will be functional in the safety code of Italy.
Short press the button several times until “Auto Test CEI 0-21” displays on the screen,
press and hold the button 3 seconds to activate “Auto Test”. After the auto test 󽗉nished,
short press the button several times until the screen displays “Auto Test Record”, and
hold the button 3 seconds to check the test result.
Connect the AC cable, auto test will start after the inverter connected to the grid, see the
operation steps below:
Main Window
General Settings
Remoted Cmd
1
Local Cmd
1
Password
1111
Setting OK
Auto Test
CEI 0-21
Test Record
IPS Item
xxxxx
Test Result
Display
IPS Item
Testing
IPS Pass/Fail
IPS Item
Test All
IPS Item
Test Null
Verified
OK
Password
1111
Wait
WaitWait
Select
Items
Wait
If
Tested
Short press(1s),switch window
Long press(3s),enter the lower Menu
General Settings
Short press(1s),switch window Long
press(3s),enter the lower Menu
No need to press, just wait
Test Pass/Fail Auto Test CEI 0-21 Auto Test Record
IPS Item Test Null Password 1111 Test Result Display
IPS Item Test All IPS Item xxxxx
If
Tested
Select
Items
Note
① IPS Items including : Test Null , 59.S1 Test , 59.S2 Test , 27.S1 Test , 27.S2 Test,81＞ .S1
Test , 81＞ .S2 Test , Test ALL.