Super Circuits DVQ-2 - Page 9

1) LED Indicators
The following LEDs will be on when:
• HDD (Hard Drive): HDD is reading or recording
• HDD Full: HDD is full.
• ALARM: Alarm is triggered
• TIMER: When timer recording is turned on
• PLAY: Under playing status
• REC: Under recording status
2) MENU
Press “MENU” button to enter the main menu.
3) ENTER / SET
• Press “ENTER” button to confi rm the setting.
• Press “SET” to change the position of the channel display.
• Press up/down/left/right direction buttons to select the channel that you want to change.
• Press “+“ or “-“ to select the channel you would like to display.
• Channel Display Position
Under the live mode, you can switch the positions of two channels by:
• Step1: Press “Set” to highlight one channel.
• Step2: Press “UP“, “DOWN”, “LEFT”, “RIGHT” button to change the channel position.
• Step3: Press “+” or “-” to select the channel.
• Step4: Press “ENTER” button to confi rm the setting.
Under the playback mode, you can select a channel to display in live video:
• Step1: Press “Set” to highlight one channel.
• Step2: Press “UP“, “DOWN”, “LEFT”, “RIGHT” button to select the channel you want to view.
• Step3: Press “+” or “-” to select the channel.
• Step4: Press “ENTER” button to confi rm the setting.
4) SEARCH
Press “SEARCH” button to enter the search menu.
5) SLOW
Under the playback mode, press “SLOW” button to decrease (1/2X) speed playback.
6) ZOOM
Press “ZOOM” button to enlarge the picture area.
9