10
1. HANDLEBAR INSTALLATION
A. Use the 5 mm hex wrench to remove the bolts from the handlebar clamp.
B. Once the clamp is open, place the lower crossbar of the handlebar in the
groove of the top crown.
C. Loosely tighten the handlebar clamp with the 5 mm hex wrench, and adjust
the angle of the handlebar to the rider’s comfort.
D. Cross-tighten the handlebar clamp from corner-to-corner making sure the
clamp is tight and the handlebars do not move.
ASSEMBLY INSTRUCTIONS
A
C
D
B
DANGER !
Do NOT ride your SUPER73 if it has been assembled incorrectly. Riding an incorrect-
ly assembled e-bike will give rise to a risk of injury, death and/or property damage.
Before you ride your e-bike (including before the first use and before all subsequent
uses), perform the Pre-ride Safety Check on pg. 14.
To Next Page
Loading...
