29
SEAT
It is not possible to adjust the seat height of the SUPER73 e-bike. It is fixed to the
frame by bolts. The minimum seat clamping torque on the frame is 6.78 Nm (5lb /ft).
For maintenance, use a cloth and water with a gentle soap for cleaning. Avoid leaving
the seat too long in the sun, as the fabric can be damaged by the sun’s UV rays. Avoid
wearing clothes that may puncture or tear the seat.
!
LIGHTING SYSTEM
SUSPENSION
Suspension components will require regular maintenance, cleaning, and greasing in
order to keep the movement of these components fluid and in good working order. It
is recommended to regularly inspect the suspension for signs of damage or wear.
Failure to maintain, check, and properly adjust the suspension system may result in
suspension malfunction, which could result in serious personal injury or damage to
the e-bike.
!
The SUPER73 S2 includes a lighting system that is directly connected to the bike’s
electrical system. If either the rear or front light is no longer operable, please contact
SUPER73 for troubleshooting and parts orders. Replacement components should be
purchased directly from SUPER73. Please avoid the use of any third-party component
that connects directly to the e-bike’s electrical system. There are no batteries in the
lights. Make sure the front and rear lights are clean before riding. If they are dusty, or
dirty, clean them with a damp cloth for optimal visibility and safety.
The e-bike and its parts are subject to wear and tear, like other mechanical products
and parts. Moreover, various materials and parts react differently to wear and
abrasion. If the life of a component is exceeded, it is possible that it will suddenly fail,
which may present hazards to the rider. Any type of cracks, streaks, or color changes
in highly stressed components could indicate the failure of the component. It is highly
recommended that use of the e-bike is suspended until all failed components are
replaced. It is important to use genuine, properly specified parts for safety-critical
components during the replacement of worn parts.
To Next Page
Loading...
