5-9
Chapter 5: Chassis Setup and Maintenance
1
4
1
5
Figure 5-9. Securing the Rear Hard Drive Cage to the Chassis
1
7
1
6
4. Loosen the two screws outside and one screw inside the opening of the hard
drive cage as illustrated.
5. Orient the 2.5" rear hard drive cage as shown, aligning the opening at the
end of the cage with the opening at the back of the chassis. Place the hard
drive cage into the chassis.
6. Secure the front of the hard drive cage to the chassis by fastening one screw
inside the opening of the hard drive cage as illustrated. Secure the top of the
hard drive cage to the chassis frame with two screws, fastened at the upper
edge of the hard drive cage above the opening of the hard drive cage.
7. Secure the back of the hard drive cage to the chassis with one screw as
shown above.
8. Replace the power cords and power up the server.
To Next Page
Loading...
