Supermicro SC825 Series - 4-2 Control Panel Buttons; 4-3 Control Panel LEDs

SC825 Chassis Manual
4-2
• Power Failure: 
supply.
• Information LED: See the following table for the status shown by this LED.
• Power: The main power switch is used to apply or remove power from the
󰀨
removes the main power but keeps standby power supplied to the system.
Therefore, you must unplug system before servicing.
4-3 Control Panel LEDs
The control panel located on the front of the SC825 chassis has six LEDs. These
󰀨
This section explains what each LED indicates when illuminated and any correc-
tive action you may need to take.
• Reset: The reset button is used to reboot the system.
4-2 Control Panel Buttons
There are two push-buttons located on the front of the chassis. These are (in order
󰀨
!