Supermicro SC825 Series - 5-9 Installing the Air Shroud

5-19
Chapter 5: Chassis Setup and Maintenance
5-9 Installing the Air Shroud
󰀩
shroud does not require screws to set up.
Figure 5-16. Air Shroud for SC825LP Chassis
Installing the Air Shroud
1. 
labeled SC825LP or SC825U,
2. Power down the system and remove the power cords from the rear of the
power supply. Open the chassis cover as described in Section 5-3.
3. 
closest to the power supply.
Note that if a 16 DIMM (13.68" x 13") motherboard is used, it is necessary to use
the optional MCP-310-82502-0N air shroud. For ordering information, visit the
Supermicro website at www.supermicro.com and click on the Where to Buy link.