SC825 Chassis Manual
5-18
PCI Slot Setup for SC825U (Universal Output) and
SC825W
SC825U and SC825W chassis accepts a slightly smaller "L" shaped motherboard to
allow for a universal expansion card. This universal output card allows the systems
to accept SAS, SCSI, IB, Ethernet, and other types of connections.
A. The SC825U/SC825W chassis accepts three full-length, full-height expansion
cards instead of four. The fourth slot is used for the UI/O card (SC825U) or a
4x full-height, full-length card (SC825W).
B. The SC825U/SC825W chassis includes a bracket that extends from the fan row
to the back of the chassis. This bracket provides support for the riser card.
Installing a Universal Input/Output Card in the SC825U chassis:
1. Power down the system and remove the power cords from the rear of the
power supply. Open the chassis cover as described in Section 5-3.
2. Connect the universal input/output to the motherboard using the slots
provided on the motherboard and the back panel.
3. Secure the card to the chassis using the four screws provided with the
chassis packaging.
Installing Add-on Cards in the SC825U and SC825W Chassis
1.
chassis cover.
2. If you are using a universal input/output card, make sure it is installed before
continuing (applies only to the SC825U).
3.
4. Secure the card to the chassis using the four screws provided with the
chassis packaging.
To Next Page
Loading...
