Appendix A: Rack Installation
44
Installing the Inner Rails
Begin the rack mounting procedure by installing the inner rails to the switch.
1. Identify the left and right inner rails. They are labeled.
2. Place the inner rail rmly against the side of the switch, aligning the holes on the side of
the switch with the holes in the inner rail.
3. Slide the inner rail toward the rear of the switch until the quick release bracket snaps
into place, securing the rails to the switch.
4. Further secure the inner rails to the switch with the at head screws size M3 and M4.
M3 Flat Head Screw
M4 Flat Head Screw
Inner Rail
Figure A-3. Installing the Inner Rail
To Next Page
Loading...
