45
Appendix A: Rack Installation
2. The free end of the rider includes a holder, which can be extended. Ensure the holder is
not extended at this point. Then, push the outer rail’s rider inwardly until the holder can
just clear the mounting slots of the rack’s back support, but abuts the un-slotted side
beam of the support.
Installing Outer Rails onto the Rack
Follow the steps below to assemble and install the outer rails on the rack.
Installing the Outer Rails on the Rack
1. The outer rails each include a sleeve and a rider. Place the tab that protrudes from the
free end of the sleeve into a post-hole slot on the front support of the rack such that the
tab ts squarely into the slot.
Outer Rail Sleeve
Outer Rail Rider
A rider slides within a sleeve to
adjust the length of an outer rail.
Position the outer rail sleeve on the front support of the rack rst.
The holder should just clear the slotted part of the
support and abut the side of the rack support.
Holder
To Next Page
Loading...
