Appendix A: Rack Installation
46
3. The outer rail is now the proper length. Without changing its length, take the outer rail
o the rack.
4. Secure the sleeve to the rider with M3 pan head screws to maintain this length.
5. Once the outer rails have been adjusted for length, place them onto the rack.
6. The holder includes a tab which protrudes from its structure. Position the tab over the
desired post-hole slot on the rack’s rear support, then slide the holder’s tab into the slot.
Use an M3 pan head screw to lock the holder in place.
Secure the holder with M3 pan head screws.
The holder’s tab should protrude through the post hole slot.
To Next Page
Loading...
