Chapter 6: Advanced Chassis Setup
6-3
6-3 Chassis Cover
ventilation and cooling.
Removing the Chassis Cover and Protective Film (Figure 6-2)
1. Unplug the AC power cord from any external power source.
2. Remove the two screws which secure the top cover onto the chassis as
shown above.
3. Lift the top cover up and off the chassis.
4.
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
6. Replace the chassis cover and reconnect the AC power cord.
Figure 6-2. Removing the Chassis Cover
Caution: Except for short periods of time, do NOT operate the server without the
overheating.
Remove two
screws
Check Ventilation
Openings
1
4
1
5
1
2
1
3
To Next Page
Loading...
