Supermicro SUPERSERVER 2028TP-HC0R - Air Shrouds

6-4
SUPERSERVER 2028TP-HC0R/HC0TR/HC0FR USER'S MANUAL
6-4 Air Shrouds

requires air shrouds for each serverboard node. Air shrouds vary depending upon
the serverboard used. See the illustrations below.
Installing an Air Shroud (Figure 6-3)
1. Make sure that the serverboard expansion card (if applicable) and all
components are properly installed in each serverboard node.
2. 
shroud sits behind the system fans and goes over the top of the serverboard
and its components.
3. Repeat the procedure for the remaining three serverboard nodes.
Figure 6-3. Installing the Air Shroud
Air Shroud
Note: the serverboards shown in this chapter are for illustrative purposes only.