Supermicro SuperServer 7089P-TR4T - Quick Reference to the Components on the AOM-X11 Opi-LBG

21
Chapter 1: Introduction
Quick Reference to the Components on the AOM-X11OPi-LBG
Jumpers on the AOM-X11OPi-LBG
Jumper Description Default Setting
JBT1 Clear CMOS Open (Normal)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPME1 ME Manufacturing Mode Select Pins 1-2 (Normal)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset)
Connectors on the AOM-X11OPi-LBG
Connector Description
Battery (BT1) Onboard CMOS Battery (See Chpt. 3 for used battery disposal)
I-SATA3 Powered SATA 3.0 connector with a power pin built-in. (SuperDOM) supported by Intel PCH
I-SATA4 Powered SATA 3.0 connector with a power pin built-in. (SuperDOM) supported by Intel PCH
IPMI LAN IPMI-dedicated LAN (J9) supported by the Baseboard Management Controller (BMC)
J1 M.2 connector used for SATA 3.0 (from I-SATA2) or PCI-E 3.0 x4 (from PCH) support
J2 M.2 connector used for SATA 3.0 (from I-SATA1) or PCI-E 3.0 x4 (from PCH) support
J5 Guide pin
J6 Power connector
JP1 DVD ROM power header (optional)
JRK1 RAIDKey header
JSD1/JSD2 Power Connectors 1/2 for I-SATA DOM (Disk_on_Module) devices
JSIOM1
SIOM (Super I/O Module) PCI-E 3.0 x16 slot supported by CPU3 for use of a Supermicro-
proprietary add-on card
JTPM1 TPM (Trusted Platform Module)/Port 80 header
JUSB1 Type A USB 3.0 header with support of USB 3.0 Port1, USB 2.0 Port2
JUSB2 USB 2.0 header with support of USB 5/USB 6
JUIDB1 UID (Unit Identication) button
LED Indicators on the AOM-X11OPi-LBG
LED Description
BMC_HB_LED1 BMC Heartbeat LED indicator (Green Blinking: BMC Normal)
LED1 Unit Identier LED indicator (Blue: Unit Identied) (See Note 2 below.)