Supermicro SuperServer 7089P-TR4T - CPU Modules; Removing;Installing a CPU Module

SuperServer 7089P-TR4T User's Manual
42
Figure 3-1. Removing a CPU Module
3.3 CPU Modules
Removing/Installing a CPU Module
1. Begin by removing power from the system as described in Section 3-1.
2. Pull the top thumb lock outward while slightly lifting the top lever. Repeat this procedure
for the bottom thumb lock and lever.
3. Lift the top lever up while simultaneously pushing the bottom lever down all the way until
the CPU module pops out.
4. With both levers fully released, grasp them both and pull the module outward to remove
it from the enclosure as shown in Figure 3-1.
5. Put the module on a at, non-conductive surface before removing or installing any
components.
4
2
3
3