Supermicro SuperServer 7089P-TR4T - Page 75

75
Chapter 4: Board Connections
VGA Enable
Jumper JPG1 allows the user to enable or the VGA support in your system. The default setting
is "1-2" to enable the connection. Refer to the table below for jumper settings.
VGA Enable
Jumper Settings
Jumper Setting Denition
1-2 Enabled (Default)
2-3 Disabled
Manufacturer Mode Select
Close pin 2 and pin 3 of Jumper JPME1 to bypass SPI ash security and force the system
to operate in the Manufacturer mode, allowing the user to ash the system rmware from
a host server for system-setting modications. Refer to the table below for jumper settings.
ME Mode Select
Jumper Settings
Jumper Setting Denition
1-2 Normal (Default)
2-3 Manufacturer Mode
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that can reset the system when a software application
hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate
a non-maskable interrupt signal for the application that hangs. Refer to the table on the below
for jumper settings. Watch Dog must also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset (Default)
Pins 2-3 NMI
Open Disabled