Supermicro SuperServer 7089P-TR4T - Page 78

78
SuperServer 7089P-TR4T User's Manual
DOM Power Connectors
Two power connectors for SATA DOM (Disk_On_Module) devices are located at JSD1/JSD2.
Connect appropriate cables here to provide power support for your Serial Link DOM devices.
DOM PWR
PinDenitions
Pin# Denition
1 +5V
2 Ground
3 Ground
RAID Key
The Intel RAID key header (JRK1) is used to enable RAID support for your system. Connect
an appropriate cable here to provide RAID support to your SATA devices. See the table below
for the pin out denitions for JRK1.
RAID Key
PinDenitions
Pin# Denition
1 Ground
2 PU 3.3V Standby
3 Ground
4 PCH RAID Key
IPMI LAN
An IPMI_dedicated LAN, located on the AOM-X11OPi-LBG, provides KVM support for IPMI
2.0. This port accepts an RJ45_type cable.
IPMI LAN Activity LED (Right)
LED State
LED Color Status Denition
Yellow Blinking Active
IPMI LAN LED Indicators
The IPMI LAN has two LED indicators. The yellow LED on the right indicates activity, while
the green LED on the left indicates the speed of the connection. Refer to the table below for
LED settings.
Link LED
Activity LED
IPMI LAN
IPMI LAN Link LED (Left)
LED State
LED Color Denition
O󰀨 10 Mbps
Green 100 Mbps
Amber 1 Gbps