66
SuperServer E302-9A User's Manual
Maximum Read Request
Select Auto for the system BIOS to automatically set the maximum size for a read request
for a PCI-E device to enhance system performance. The options are Auto, 128 Bytes, 256
Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
ASPM Support
Use this item to set the Active State Power Management (ASPM) level for a PCI-E device.
Select Auto for the system BIOS to automatically set the ASPM level based on the system
to L0s state. The options are Disabled, Auto, and Force L0s.
Warning: Enabling ASPM support may cause some PCI-E devices to fail!
ARI Forwarding
Device immediately below the port. The options are Disabled and Enabled.
CPU SLOT7 PCI-E 3.0 X4 OPROM
Disabled, Legacy, and EFI.
M.2 PCI-E 3.0 X2 OPROM
Disabled, Legacy, and EFI.
Onboard LAN Option ROM Type
Use this item to select the Onboard LAN Option ROM type. The options are Disabled, Legacy,
and EFI.
Onboard Video Option ROM
Use this item to select the Onboard Video Option ROM type. The options are Disabled,
Legacy, and EFI.
VGA Priority
Use this item to select the active video type. The options are Onboard
Network Stack
Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If "Network Stack" is set to Enabled, the following items will display:
Ipv4 PXE Support
Use this feature to enable Ipv4 PXE Boot Support. If this feature is disabled, it will not create
the Ipv4 PXE Boot option. The options are Disabled and Enabled.
To Next Page
Loading...