67
Chapter 6: UEFI BIOS
Ipv6 PXE Support
Use this feature to enable Ipv6 PXE Boot Support. If this feature is disabled, it will not create
the Ipv6 PXE Boot option. The options are Disabled and Enabled.
PXE Boot Wait Time
Use this feature to select the wait time to press the ESC key to abort the PXE boot. The
default is 0.
Media Detect Count
Use this feature to select the wait time in seconds to detect LAN media. The default is 1.
Super IO Conguration
Super IO Chip AST2400
Serial Port 1 Conguration
COM1
Serial Port 1
Enabled and Disabled.
Device Settings
This item displays the base I/O port address and the Interrupt Request address of a serial
Note: This item is hidden when Serial Port 1 is set to Disabled.
Serial Port 1 Change Settings
Port 1. Select Auto for the BIOS to automatically assign the base I/O and IRQ address to
Auto, (IO=3F8h; IRQ=4), (IO=3F8h; IRQ=3, 4, 5,
6, 7, 9, 10, 11, 12), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12); (IO=3E8h; IRQ=3, 4, 5, 6,
7, 9, 10, 11, 12), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12).
Serial Port Console Redirection
COM 1 Console Redirection
Select Enabled to enable COM Port 1 for Console Redirection, which will allow a client
machine to be connected to a host machine at a remote site for networking. The options are
Enabled and Disabled.
To Next Page
Loading...