Supermicro SuperWorkstation 7049GP-TRT - Page 44

44
SuperWorkstation 7049GP-TRT User's Manual
HD Audio Enable


HD Audio Enable/Disable
Jumper Settings
Jumper Setting Denition
Open Enabled (Default)
Short Disabled
Onboard Audio Enable
JPAC1 allows you to enable or disable the onboard audio support. The default position is on

Audio Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default
setting is Reset.
Note: When Watch Dog is enabled, the user needs to write their own application
software to disable it.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Manufacturing Mode Select



Manufacturing Mode Select
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode