Chapter 1: Overview
1-5
Jumper Description Default
JPB1 BMC Enable/Disable Pins 1-2 (Enabled)
JPG1 Onboard VGA Enable Pins 1-2 (Enabled)
JBR1 BIOS Recovery Mode Pins 1-2 (Normal)
JPME2 Intel ME Recovery Mode Pins 1-2 (Normal)
JBT1 Clear CMOS/Reset BIOS Conguration (See Chpt. 2)
JPS1 SAS Enable Pins 1-2 (Enabled)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset)
JPL1, JPL2 LAN1, LAN2 Enable/Disable Pins 1-2 (Enabled)
JPTG1 10Gb LAN Support Enable/Disable Pins 1-2 (Enabled)
J21 LAN Controller EEPROM update Open (Dsiabled)
JI2C1/JI2C2 SMB to PCI-E Slots Pins 2-3 (Disabled)
X10DRL-CT/-iT/-C Jumpers
Connector Description
I/O Back Panel See Back Panel I/O Connectors, Section 2-6
COM1 On board Serial port header for COM1
JL1 Chassis Intrusion Header
I-SATA0~5 SATA Interface for SATA1, 2, 3, 4, 5 and 6
USB 2/3 USB 2.0 Header for USB ports 2/3
JSD1 Power Connector for DOM (Disk on Module) Device
USB 8/9 (3.0) USB 3.0 Header for USB ports 8/9
USB4 USB 2.0 Type A port for USB 4
JF1 Front Panel Control/LED Header
FAN1~6, FANA/B CPU/System Fan Headers
L-SAS0~3, L-SAS4~7 L-SAS Interface for SAS0~7
JTPM1 TPM (Trusted Platform Module) / Port 80 Header
I-SGPIO1/I-SGPIO2 Serial General Purpose I/O Headers 1 and 2
JD1 Speaker/Power LED
JS18 LSISAS3108 TFM connector
JIPMB1 System Management Bus header
JSTBY1 Standby Power Connector
JUIDB1 UID (Unit ID) Switch
JNVI2C1 PCI-E NVMe AOC I2C Header
JPWR1, JPWR2 8-pin ATX Power Connectors
JPI2C1 Power Supply SMBus I2C Header
J24 24-pin ATX Power Connector
X10DRL-CT/-iT/-C Connectors
To Next Page
Loading...
