1-6
X10SLM+/X10SLL+ Motherboard Series User's Manual
Jumpers
JBR1 BIOS Recovery Pins 1-2 (Normal)
JBT1 CMOS Clear Short pin pads to reset CMOS
JI
2
C1/JI
2
C2 SMB to PCI Slots Off (Disabled)
JPL1/JPL2 LAN1/LAN2 Enable Pins 1-2 (Enabled)
JPL3/JPL4 LAN3/LAN4 Enable (-LN4F only) Pins 1-2 (Enabled)
JPME1 Management Engine (ME) Recovery Pins 1-2 (Normal)
JPME2 Manufacture Engine (ME) Mode Select Pins 1-2 (Normal)
JWD1 Watch Dog Reset Timer Enable Pins 2-3 (NMI)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
SW1 Unit ID (UID) LED Switch Toggle On or Off (for UID LED)
J21 LAN Firmware Update Jumper Open (Disabled)
To Next Page
Loading...