Supermicro X10SLM+-F - PCIe;PCI;PnP Configuration; Above 4 G Decoding

4-16
X10SLM+/X10SLL+ Motherboard Series User's Manual
SATA Gen3 Port 0 ~ Port 5 Length Value
Set this item to select a value for Gen3 length test. The values that can be
selected ranges from [00 0000b] through [00 1111b].
SATA Gen2 Port 0 ~ Port 5 Length Value
Set this item to select a value for Gen2 length test. The values that can be
selected ranges from [00 0000b] through [00 1111b].
If RAID is selected in SATA Mode Selection above, the following items are displayed:
Serial ATA Port 0 ~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
• Model number of drive and capacity
• Software Preserve Support
Port 0 ~ Port 5 Hot Plug
This feature designates this port as hot pluggable. Set this item to Enabled to
enable hot-plugging. The options are Hard Disk Drive and Solid State Drive.
Port 0 ~ Port 5 SATA Device Type
This feature congures the selected SATA port to support either a solid state
drive or hard disk drive. Set this item to Enabled to enable hot-plugging. The
options are Enabled and Disabled.
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization sequence to the device. The options are Enabled and Disabled.

PCIe/PCI/PnP Conguration
This feature allows the user to set the PCI/PnP congurations for the following items:
Above 4G Decoding
Select Enabled for 64-bit devices to be decoded above the 4GB address space
if 64bit PCI decoding is supported by the system. The options are Disabled and
Enabled.