Supermicro X10SLM+-F - EFI Logging and BMC Network Configuration

4-26
X10SLM+/X10SLL+ Motherboard Series User's Manual
Select No to keep all system event logs after each system reboot. The options are
No, Yes, On next reset, and Yes, On every reset.
When SEL is Full
This feature allows the user to decide what the BIOS should do when the system
event log is full. Select Erase Immediately to erase all events in the log when the
system event log is full. The options are Do Nothing and Erase Immediately.
Custom EFI Logging Options
Log EFI Status Codes
Select Enabled to log EFI (Extensible Firmware Interface) Status Codes, Error
Codes or Progress Codes. The options are Enabled and Disabled.
Note: After making changes on a setting, be sure to reboot the system for
the changes to take effect.
BMC Network Conguration
LAN Channel 1: This feature allows the user to congure the settings for LAN1 Port.
Update IPMI LAN Conguration
This feature allows the user to decide if the BIOS should congure the IPMI setting
at next system boot. The options are No and Yes. If the option is set to Yes, the
user is allow to congure the IPMI settings at next system boot:
IPMI LAN Selection
This feature allows the user to congure the IPMI LAN setting. The default setting
is Failover.
IPMI Network Link Status
This feature displays the status of IPMI Network Link connections.
Conguration Address Source
This feature allows the user to select the source of the IP address for this computer.
If Static is selected, you will need to know the IP address of this computer and enter
it to the system manually in the eld. If DHCP is selected, the BIOS will search for
a DHCP (Dynamic Host Conguration Protocol) server in the network that is at-
tached to and request the next available IP address for this computer. The options
are DHCP and Static. The following items are assigned IP addresses automatically
if DHCP is selected, or can be congured manually if Static is selected.