Supermicro X11DPU - Page 15

Note: The table above is continued on the next page.
15
Chapter 1: Introduction
Motherboard Features
I/O Devices
• Serial (COM) Port • One (1) Fast UART 16550 port on the I/O back panel
• SATA 3.0
• Eight (8) SATA 3.0 connections supported by Intel® PCH (I-SATA 0-3, 4-7)
• Four (4) SATA 3.0 connections supported by Intel® SCU (S-SATA 0-3)
• Two (2) SATA 3.0 ports with power-pin built-in, w/support of Supermicro
SuperDOM (S-SATA4/S-SATA5)
• RAID (PCH) • RAID 0/1/5/10 (RSTe 5.0)
Peripheral Devices
• Two (2) USB 3.0 ports on the rear I/O panel (USB 0/1)
• One (1) internal USB 3.0 header with two (2) USB connections on the motherboard for front access (USB 3/4)
• One (1) Type A USB 3.0 connector for front access (USB 2)
BIOS
• 64 MB SPI AMI BIOS
®
SM Flash UEFI BIOS
• ACPI 3.0/4.0, USB keyboard, Plug-and-Play (PnP), SPI dual/quad speed support, riser-card auto detection support, and
SMBIOS 2.7 or later
Power Management
• Main switch override mechanism
• Power-on mode for AC power recovery
• Intel® Intelligent Power Node Manager 4.0 (available when the Supermicro Power Manager [SPM] is installed and a
special power supply is used. See the note on page 22.)
• Management Engine (ME)
System Health Monitoring
• Onboard voltage monitoring for +3.3V, 3.3V standby, +5V, +5V standby, +12V, CPU core, memory, chipset, BMC, PCH,
and battery voltages
• CPU System LED and control
• CPU Thermal Trip support
• Status monitor for speed control
• Status monitor for on/off control
• CPU Thermal Design Power (TDP) support of up to 165W (See Note 1 on next page.)
Fan Control
• Fan status monitoring via IPMI connections
• Dual cooling zone
• Low-noise fan speed control
• Pulse Width Modulation (PWM) fan control
System Management
• Trusted Platform Module (TPM) support
• PECI (Platform Environment Control Interface) 2.0 support
• UID (Unit Identication)/Remote UID
• System resource alert via SuperDoctor® 5
• SuperDoctor® 5, Watch Dog, NMI
• Chassis intrusion header and detection