Supermicro X11SPW-CTF - Page 16

16
X11SPW-CTF/-TF User's Manual
Note: The table above is continued on the next page.
Motherboard Features
I/O Devices
• Serial (COM) Port
• One (1) serial port on the rear I/O panel (COM1)
• One (1) front accessible serial port header (COM2)
• SATA 3.0 • Ten (10) SATA 3.0 ports (I-SATA0~7, S-SATA0~1) supported by the C622
• RAID (PCH) • RAID 0, 1, 5, 10
• SAS 3.0 (X11SPW-CTF only) • Four (4) SAS 3.0 connections via LSI3008 with one mini-SAS HD (SAS0-3)
• RAID (LSI3008) • RAID 0, 1, 10
Peripheral Devices
• Two (2) USB 2.0 ports on the rear I/O panel (USB0/1)
• Two (2) USB 3.0 ports on the rear I/O panel (USB7/8)
• Three (3) USB 2.0 headers for front access (USB2/3, USB4/5, USB6) (Not customized for front panel)
• One (1) USB 3.0 header for front access (USB10/11)
• One (1) USB 3.0 Type-A header (USB9)
BIOS
• 256 Mb SPI AMI BIOS
®
SM Flash UEFI BIOS
• ACPI 4.0a, SMBIOS 2.7, BIOS rescue hot-key, Plug-and-Play (PnP), SPI dual/quad speed support, Riser card auto
detection support, RTC (Real Time Clock) wakeup
Power Management
• Power button override mechanism
• Power-on mode for AC power recovery
• Wake-on-LAN
• Intel® Intelligent Power Node Manager 3.0 (available when the Supermicro Power Manager [SPM] is installed and a
special power supply is used. See the note on page 21.)
• Management Engine (ME)
• ACPI Power Mangement
System Health Monitoring
• Onboard voltage monitoring for +1.05V, +1.2V, +1.8V, +3.3V, +3.3V standby, +5V, +5V standby, +12V, VBAT, Memory,
PCH Temp., System Temp., Memory Temp.
• CPU switch phase voltage regulator
• CPU Thermal Trip support
• Status monitor for speed control
• Status monitor for on/off control
• CPU Thermal Design Power (TDP) support of up to 205W (See Note 1 on next page.)
Fan Control
• Fan status monitoring via IPMI connections
• Single cooling zone
• Low-noise fan speed control
• Seven (7) 4-pin fan headers