23
Chapter 2: Installation
SAN MAC
DESIGNED IN USA
BIOS LICENSE
+
+
MH10
X11SSH-GF-1585L
REV:1.01
MAC CODE
IPMI CODE
BAR CODE
JSD2
JSD1
JSTBY1
JTPM1
LED2
LEDM1
JPWR2
JPWR1
J23
MH8
MH9
JUIDB1
SP1
JD1
J3
JPI2C1
JL1
JBT1
I-SATA2
I-SATA3
I-SATA5
I-SATA4
I-SATA7
I-SATA6
JF1
LED1
BAT1
JPL1
JVRM2
JWD1
JPME2
JVR1
JPB1
JVRM1
JPG1
J24
JI2C2
JLED1
JBR1
JI2C1
I-SGPIO1
FANA
FAN3
FAN2
FAN1 (CPU FAN)
FAN4
PCH SLOT4 PCI-E 3.0 X4 (IN X8)
Intel®
C236
IPMI_LAN
USB10/11 (3.0)
USB2/3
CPU SLOT5 PCI-E 3.0 X8
USB6/7USB4/5
M.2 CONNECTOR
CPU SLOT6 PCI-E 3.0 X8 (IN X16)
USB12 (3.0)
VGA
LAN2
DIMMB1
LAN1
DIMMB2
DIMMA2
DIMMA1
CPU
USB8/9
(3.0)
USB0/1
NMI
LED
X
1 LED2FAIL LED
RST
JF1
ON
PWRNIC HDDNICPS UIDPWR
COM2
COM1
2.2 Motherboard Installation
All motherboards have standard mounting holes to t different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Location of Mounting Holes
Note: 1) To avoid damaging the motherboard and its components, please do not use
a force greater than 8 lb/inch on each mounting screw during motherboard installation.
2) Some components are very close to the mounting holes. Please take precautionary
measures to avoid damaging these components when installing the motherboard to
the chassis.
Philips
Screwdriver (1)
Standoffs (8)
Only if Needed
Philips Screws (8)
Tools Needed
To Next Page
Loading...
