Supermicro X11SSH-GF-1585 - Super Io Configuration

Chapter 4: BIOS
81
XHCI Hand-Off
This item is for operating systems that do not support eXtensible Host Controller Interface
(XHCI) hand-off. When this item is enabled, XHCI ownership change will be claimed by the
XHCI driver. The settings are Enabled and Disabled.
Port 60/64 Emulation
Select Enabled for I/O port 60h/64h emulation support which will provide complete USB
keyboard legacy support for the operating system that does not support Legacy USB devices.
The options are Disabled and Enabled.
Super IO Conguration
The following Super IO information will be displayed:
• Super IO Chip
Serial Port 1
This submenu allows the user the congure settings of Serial Port 1.
Serial Port 1
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This item displays the current status of a serial part specied by the user.
Serial Port 1 Change Settings
This feature species the base I/O port address and the Interrupt Request address of a
serial port specied by the user. Select Auto to allow the BIOS to automatically assign the
base I/O and IRQ address.
The options for Serial Port 1 are Auto, (IO=3F8h; IRQ=4), (IO=3F8h; IRQ=3, 4, 5, 6, 7, 9,
10, 11, 12), (IO=2F8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12), (IO=3E8h; IRQ=3, 4, 5, 6, 7, 9, 10,
11, 12), and (IO=2E8h; IRQ=3, 4, 5, 6, 7, 9, 10, 11, 12).
Serial Port 2
This submenu allows the user the congure settings of Serial Port 2.
Serial Port 2
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
Device Settings
This item displays the current status of a serial part specied by the user.