Supermicro X11SSH-GF-1585 - Page 46

46
X11SSH-GF/-GTF (-1585/-1585L) User's Manual
SMBus to PCI Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to connect the System Management Bus (I
2
C) to the
PCI-E/PCI slots. Both jumpers must be set to the same setting (JI
2
C1 controls the clock and
JI
2
C2 controls the data).
SMBus to PCI Slots
Jumper Settings
JI
2
C1 Setting JI
2
C2 Setting Denition
JI
2
C1: Closed JI
2
C2:Closed Enabled
JI
2
C1: Open JI
2
C2: Open Disabled
SAN MAC
DESIGNED IN USA
BIOS LICENSE
+
+
MH10
X11SSH-GF-1585L
REV:1.01
MAC CODE
IPMI CODE
BAR CODE
JSD2
JSD1
JSTBY1
JTPM1
LED2
LEDM1
JPWR2
JPWR1
J23
MH8
MH9
JUIDB1
SP1
JD1
J3
JPI2C1
JL1
JBT1
I-SATA2
I-SATA3
I-SATA5
I-SATA4
I-SATA7
I-SATA6
JF1
LED1
BAT1
JPL1
JVRM2
JWD1
JPME2
JVR1
JPB1
JVRM1
JPG1
J24
JI2C2
JLED1
JBR1
JI2C1
I-SGPIO2
I-SGPIO1
FANA
FAN3
FAN2
FAN1 (CPU FAN)
FAN4
PCH SLOT4 PCI-E 3.0 X4 (IN X8)
Intel®
C236
IPMI_LAN
USB10/11 (3.0)
USB2/3
CPU SLOT5 PCI-E 3.0 X8
USB6/7USB4/5
M.2 CONNECTOR
CPU SLOT6 PCI-E 3.0 X8 (IN X16)
USB12 (3.0)
VGA
LAN2
DIMMB1
LAN1
DIMMB2
DIMMA2 DIMMA1
CPU
USB8/9
(3.0)
USB0/1
NMI
LED
X
1 LED2FAIL LED
RST
JF1
ON
PWRNIC HDDNICPS UIDPWR
COM2
COM1
1. SMBus to PCI Slots
2. BMC Enable/Disable
BMC Enable/Disable
JPB1 is used to enable or disable the BMC (Baseboard Management Control) chip and the
onboard IPMI connection. This jumper is used together with the IPMI settings in the BIOS.
After the BMC is disabled, IPMI health monitoring and remote management functions are
no longer supported. This jumper is for debugging only.
Note: Please always keep BMC enabled to make sure the platform operates reliably
with the health monitor.
BMC IPMI Enable/Disable Jumper
Settings
Pin # Denition
1-2 Enabled (Default)
2-3 Disabled
1
2