Supermicro X11SSH-GF-1585 - Page 51

51
Chapter 2: Installation
Power LED Enable/Disable
An onboard Power LED header is located at JLED1. This Power LED header is connected
to the front control panel located at JF1 to indicate the status of system power. See the table
below for pin denitions.
SAN MAC
DESIGNED IN USA
BIOS LICENSE
+
+
MH10
X11SSH-GF-1585L
REV:1.01
MAC CODE
IPMI CODE
BAR CODE
JSD2
JSD1
JSTBY1
JTPM1
LED2
LEDM1
JPWR2
JPWR1
J23
MH8
MH9
JUIDB1
SP1
JD1
J3
JPI2C1
JL1
JBT1
I-SATA2
I-SATA3
I-SATA5
I-SATA4
I-SATA7
I-SATA6
JF1
LED1
BAT1
JPL1
JVRM2
JWD1
JPME2
JVR1
JPB1
JVRM1
JPG1
J24
JI2C2
JLED1
JBR1
JI2C1
I-SGPIO2
I-SGPIO1
FANA
FAN3
FAN2
FAN1 (CPU FAN)
FAN4
PCH SLOT4 PCI-E 3.0 X4 (IN X8)
Intel®
C236
IPMI_LAN
USB10/11 (3.0)
USB2/3
CPU SLOT5 PCI-E 3.0 X8
USB6/7USB4/5
M.2 CONNECTOR
CPU SLOT6 PCI-E 3.0 X8 (IN X16)
USB12 (3.0)
VGA
LAN2
DIMMB1
LAN1
DIMMB2
DIMMA2 DIMMA1
CPU
USB8/9
(3.0)
USB0/1
NMI
LED
X
1 LED2FAIL LED
RST
JF1
ON
PWRNIC HDDNICPS UIDPWR
COM2
COM1
1
1. Power LED
2. LAN1/2 Enable
2
LAN1/LAN2 Enable/Disable
Jumper JPL1 enables or disables LAN ports 1/2 on the motherboard. See the table below
for jumper settings. The default setting is enabled.
LAN Enable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (default)
Piins 2-3 Disabled
Onboard PWR LED
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled