Supermicro X11SSH-GF-1585 - Page 77

Chapter 4: BIOS
77
ASPM level based on the system conguration. Select Disabled to disable ASPM support.
The options are Disabled, L0s, L1, L0s & L1, and Auto.
SLOT4 L1 Substates
Use this feature to congure the PCI Express L1 substates. The options are Disabled,
L1.1, L1.2, and L1.1 & L1.2
SLOT4 PCIe Speed
Use this feature to select the PCI Express port speed. The options are Auto, Gen1, Gen2,
and Gen3.
SLOT4 Detect Non-Compliance
Select Enabled for the AMI BIOS to automatically detect a PCI-E device that is not compliant
with the PCI-E standards. The options are Disabled and Enabled.
PCI-E 3.0 M.2
PCI-E 3.0 M.2 ASPM Support
Use this item to set the Active State Power Management (ASPM) level for the PCI-E 3.0
M.2 device installed on the slot specied. Select Auto for the system BIOS to automatically
set the ASPM level based on the system conguration. Select Disabled to disable ASPM
support. The options are Disabled, L0s, L1, L0s & L1, and Auto.
PCI-E 3.0 M.2 L1 Substates
Use this feature to congure the PCI Express L1 substates. The options are Disabled,
L1.1, L1.2, and L1.1 & L1.2
PCI-E 3.0 M.2 PCIe Speed
Use this feature to select the PCI Express port speed. The options are Auto, Gen1, Gen2,
and Gen3.
PCI-E 3.0 M.2 Detect Non-Compliance Dev
Select Enabled for the AMI BIOS to automatically detect a PCI-E device that is not compliant
with the PCI-E standards. The options are Disabled and Enabled.
Port 61h bit-4 Emulation
Select Enabled to enable the emulation of Port 61h bit-4 toggling in SMM (System
Management Mode). The options are Disabled and Enabled.