Chapter 4: BIOS
79
Port 0 ~ Port 7 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Enabled and Disabled.
Port 0 ~ Port 7 SATA Device Type
Use this item to specify if the SATA port specied by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCIe/PCI/PnP Conguration
The following information will be displayed:
• PCI Bus Driver Version
• PCI Devices Common Settings:
PCI PERR/SERR Support
Select Enabled to support PERR (PCI/PCI-E Parity Error)/SERR (System Error) runtime error
reporting for a PCI/PCI-E slot. The options are Disabled and Enabled.
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and Enabled.
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization Support. The options are
Disabled and Enabled.
PCH SLOT4 PCI-E 3.0 X4 (IN X8) OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot
for system boot. The options are Disabled, Legacy, and EFI.
CPU SLOT5 PCI-E 3.0 X8 OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot
for system boot. The options are Disabled, Legacy, and EFI.
CPU SLOT6 PCI-E 3.0 X8 (IN X16) OPROM
Use this feature to select which rmware type to be loaded for the add-on card in this slot
for system boot. The options are Disabled, Legacy, and EFI.
Onboard LAN Option ROM Type
Select Enabled to enable Option ROM support to boot the computer using a network device
specied by the user. The options are Legacy and EFI.
To Next Page
Loading...
