Appendix D: UEFI BIOS Recovery
117
5. After the BIOS recovery process is complete, press any key to reboot the system.
6. Using a different system, extract the BIOS package into a bootable USB ash drive.
7. When a DOS prompt appears, enter FLASH.BAT BIOSname.### at the prompt.
Note: Do not interrupt this process until the BIOS ashing is complete.
8. After seeing the message indicating the BIOS update has completed, unplug the AC
power cable from the power supply, clear CMOS, then plug the AC power cable in the
power supply again to power on the system.
9. Press <Del> continuously to enter the BIOS Setup utility.
10. Press <F3> to load the default settings.
11. After loading the default settings, press <F4> to save the settings and exit the BIOS
Setup utility.
To Next Page
Loading...
Need help?
General
