4-18
X9DRG-O(T)F-CPU/X9DRG-O-PCIE Platform User’s Manual
CPU2 Slot1 PCI-E 3.0 x16 OPROM, CPU2 Slot2 PCI-E 3.0 x16 OPROM, CPU2
Slot3 PCI-E 3.0 x16 OPROM, CPU2 Slot4 PCI-E 3.0 x16 OPROM, CPU2 Slot5
PCI-E 3.0 x8 OPROM, CPU1 Slot6 PCI-E 3.0 x8 OPROM, PCI/PCIX/PCIe
Slot7 OPROM, CPU1 Slot8 PCI-E 3.0 x16 OPROM, CPU1 Slot9 PCI-E 3.0
x16 OPROM, CPU1 Slot9 PCI-E 3.0 x16 OPROM, CPU1 Slot10 PCI-E 3.0 x16
OPROM, CPU1 Slot11 PCI-E 3.0 x16 OPROM,
Select Enabled to enable Option ROM support to boot the computer using a de-
vice installed on the slot specied above. The options are Enabled and Disabled.
Onboard LAN Option ROM Select
Select iSCSI to use the iSCSI Option ROM to boot the computer from a SCSI
drive. Select PXE (Preboot Execution Environment) to use an PXE Option ROM to
boot the computer from a SCSI PXE drive. The options are iSCSI, FCoE, and PXE.
Load Onboard LAN1 Option ROM, Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1/LAN2 Option ROM. This is to boot
the computer using a network device installed in a LAN port specied. The default
setting for LAN1 Option ROM is Enabled, and the default setting for LAN2 Option
ROM is Disabled.
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary
boot device. The options are Onboard and Offboard.
Network Stack
Select Enabled enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Enabled
and Disabled.
IPv4 PXE Support (Available when the item abobe-Network Stack is set to
Enabled)
Set this item to Enabled to activate IPv4 PXE Support. The options are Enabled
and Disabled.
Super IO Conguration
Super IO Chip: This item displays the Super IO chip used in the motherboard.
WPCM450 Serial Port Attribute
If this item is set to COM/SOL, the port specied above will be used for normal
operation. Select BMC for the port specied above to be used for system debugging
only. The options are COM/SOL and BMC.
To Next Page
Loading...
Need help?
General
